Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
ND lever catch
”
RELATED FAQS
Question
Answer
What is the part number for an ND lever?
Resolution:
ND-series locks manufactured on or after January 30, 2017 use a different levers for cylinders and push/push-to-turn buttons.03-230 - Closed03-231 - Privacy & Cylinder- Schlage KIL (P,L)03-232 ...:
Why doesn't full rotation of the AD or CO Series Exit Trim (993) outside lever fully retract the Von Duprin 98/99 Exit Device latch?
Resolution:
- AD Series and CO series products require that the Night Latch (NL) screw is installed in the exit device. Be sure this screw is installed- Exit hardware and strike must be properly mounted ...:
What would keep the latch bolt on a 33A device from retracting all the way when dogged?
Resolution:
Bad dogging hook on the dogging assembly could cause the 33A/35A and 98/99 exit device latch bolt not to retract completely.:
What is the part number for the L series handing screw?
Resolution:
Screw part number is L583-485. Screw type: 8-32 UC-2A W/#6 Flat truss head Phillips recess, header point.:
Are the ND, NDe, AD and CO levers the same?
Resolution:
Between January 30, 2017 June of 2019, the AD and CO cylindrical lock levers were incompatible because of the ND / NDe lever and spring cage design change in January of 2017.Prior to January ...:
Why is the ND lever hard to push on?
Resolution:
ND locks shipping on or after January 30, 2017 no longer require the use of the soft durometer spacer. Lever installation on the redesigned ND locks should not be difficult.:
Is the blue ND lever tool shipped with each lock?
Resolution:
The blue lever tool remover, 24002693, is not shipped in every box. The existing wire spring lever removal tool will be included in every box. :