Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ mortise lock solenoid testing ”

Resolution: The resistance readings for a Falcon 24 or 25 Series EL solenoid should read;Green to Yellow = Pull Coil, should measure between 1 and 2 ohms of resistance. Green to Orange = Hold Coil, s...:

What are the benefits of E7500 and E996L-M?

Resolution: Both E7500 mortise lock and E996L-M provide electrical control of the outside trim. The E7500 mortise lock offers two monitoring switches that would not be available on the E996L-M trim. They moni...:

What is the best way to test the Von Duprin EL solenoid?

Resolution: The best way to test the Von Duprin EL solenoid is with an ohm meter. You must test both coils to make sure the solenoid is good. The coil has three wires; green, yellow, and orange. The green...:

Can the low coin cell Nuisance delay be Disabled on a CO200?

Resolution: The coin cell is ignored when the lock sets are used with Manual Programming ONLY or while in Construction mode.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ mortise lock solenoid testing ”

RELATED FAQS