Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ minimum stop width for ives coordinator ”

RELATED FAQS

Resolution: The 62A shoe is used when it is necessary to install the door closer (lower) down on the door so that it will operate under accessories such as overhead stops, coordinators, etc.:

Can a Senior Swing 9550 be mounted on an unequal pair of doors?

Resolution: "PUSH SIDE" application: Minimum 52" wide pair, with neither door being less than 21" wide. "PULL SIDE" application - For Product Shipped...:

What is the narrowest door a 99 rim, single door can fit on?

Resolution: The Minimum single door opening should be 26.32" and use the 299 or 499F strike.:

What is the minimum door width for a 98/99 Rim device with 4954 mullion?

Resolution: Minimum door opening for a 98/99 rim device with a 4954 mullion and 299 strike is 26.687" (26 11/16"):

What is the minimum clear opening width required by ADA on a single door?

Resolution: The minimum clear opening width for ADA is 32" measured from face of door opened to 90 degrees to face of stop on strike jamb. There must be no hardware mounted to the door projectin...:

What is the minimum door opening width for mounting the 4640 or 4630 on a double door?

Resolution: The minimum door opening width (for mounting a pair of 4640 or 4630 operators on a double door) is 72" wide (2 - 36" door leaves). Mounting the 4640 or 4630 on a double door that is less than 72" w...:

What is the minimum stile for Schlage locks?

Resolution: The minimum stile for each lock will depend on the backset and the rose diameter/escutcheon width. See the Schlage Minimum Stile Requirements for the minimum stile for eac...:

How is a bar coordinator installed on an aluminum frame with a 5/8" blade stop?

Resolution: This can vary based upon situation. It may be able to either "cut away" the blade stop, or mount the COR with "spacer blocks" below the stop. Allegion does not sell spacer b...: