Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ manual parts H series ”

RELATED FAQS

Question
Answer
Are the Schlage H series knobs sold separate?
The knobs are available, part numbers listed below. 01-008 for a closed knob 01-009 for open levers 01-018 for cylinder knobs, LEV lever design not available in 01-018 01-026 for FSIC Specif...
What is the part number for the Von Duprin maintenance kit?
Von Duprin has a maintenance kit part number 050046-00 and maintenance instruction, part number 941079-00 for 98/99 series devices. There are some common parts between 98/99 series and 22...
What size is the Schlage H escutcheon?
  Schlage H-Series Escutcheons    Part Number  Description Dimension   07-057  Inside escutcheon and turn  6.92" x 2.75"  07-035  Inside escutcheon, dummy - H170  6.92" x 2...
Did the H-Series deadbolt and linkage change?
As of May 23, 2011 the Schlage H-Series is assembled with the Schlage B500-Series deadbolt and a new linkage. If the deadbolt is being replaced for a lock manufactured prior to May 23rd, 2011...
What backsets are available on Schlage and Falcon locks?
SCHLAGE locks are available with the following backsets: Lock Series Lock Type                 ...
How thick of door will the standard 24/25 series device mounting package work with?
Standard mounting packages are only for a 1 3/4" thick door. Door thickness other than 1 3/4" need to be specified when ordering the device.
Can the 4630/4640 cylinder only be replaced?
The 4040(XP) door closer can be used as a temporary replacement in a 4630/4640 operator to provide manual control of the door while the 4630/4640 closer cylinder is being repaired or a replacement ...
Are there any parts available for the old Dor-O-Matic 1200 overhead concealed series closers?
The Dor-O-Matic overhead concealed manual door closers have been obsolete since 1999, and there are no parts available for them.
How do you remove the cylinder from an A series knob?
To remove the knob:  Turn key 45 degrees clockwise Push in catch push pin and pull off knob  
*The older wafer style locks did not use a knob catch.  The chassis must be disassembled before the knob can be removed because it uses the wafer lock chassis spindle.