Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
lift lever unlocks door
”
RELATED FAQS
Question
Answer
What is a Cam Lift Hinge?
Resolution:
Cam Lift Hinges are specially designed hinges used mainly on acoustical door assemblies. The Cam Lift Hinge lifts the door during its travel and seats the door bottom for a pos...:
What is a cylindrical lock?
Resolution:
Cylindrical Locks: a bored lockset whose latch or bolt locking mechanism is contained in the portion installed through the cross-bore Medium, high to extra heavy duty Commercial, mul...:
Why does the Schlage button light up “Green” when I open the door?
Resolution:
When unlocking the CO200 door by mechanical key override, the green led will be continuously ON until the key is released. This will occur after firmware CO.A.6 (or later) has been installed int...:
What is the difference between the 996 L and the 996 L-NL trim?
Resolution:
996L trim is a standard Classroom Function lever set for the 98/99 panic devices. The 996L-NL trim is a rigid lever for the 98/99 device where the key will retract the latch on the panic device bu...:
Why does my AD or CO series lock unlock when the lever is raised?
Resolution:
Installers have reported that their AD-CO Series cylindrical or mortise locks will unlock whenever the outside lever is lifted. This will occur if the outside spindle (square post) is install...:
Did Falcon ever make a lock for elevator doors?
Resolution:
Falcon manufactured an EZF101 which was a large plate with a recessed lever for use in elevators. This item is no longer available. :
Why is the key locking and/or unlocking my E996L for a 9875?
Resolution:
The 7500 mortise lock should be configured for NL function as shipped not as Classroom. See figure 4-3 in E996L instructions.:
Can a 9500 series operator on the push side be used with Cam lift hinges?
Resolution:
The Senior Swing will work with Cam Lift Hinges as a PUSH SIDE MOUNT 9542/9553/9563 only. Maximum 3/4" lift. Maximum 15 pounds force to push door up the Cam Lift Hinge. Cam Lift Hinges WILL NO...:
Outside lever on the T and RU 571's won't unlock after egress.
Resolution:
Replace the lock chassis as necessary for any T locks exhibiting this issue. RU locks need to be replaced entirely. :