Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ lever getting hot ”

RELATED FAQS

Resolution: This is usually an indicator of applying excessive voltage. Measure the voltage going into the solenoid and make sure you have 24-26.4VDC cross the two wires going into the solenoid. Also measure ...:

Can you use lever trim on a 19V-EO without getting any additional parts?

Resolution: The Exit Only (EO) device will accept any 19 Series trim as the main cam for the trim input is always put on the device center case.:

Should a solenoid be hot to the touch?

Resolution: If there is concern that the solenoid or device is "too hot" or has the capability to cause injury, disconnect the device and contact a authorized service representative to analyze the opening.:

Why would an EL 98/99 solenoid get hot?

Resolution: If voltage going into the solenoid is much higher than 24VDC it could cause the solenoid to get hot. Check the power supply output voltage to confirm. If the holding coil on EL solenoid is shor...:

How hot do the 6000 electric strikes get?

Resolution: If the solenoid of the 6000 series electric strike is powered continuously with proper voltage at room temperature, the solenoid can feel very warm to the touch. Ensure the power supply ...:

Why does my 7500 retract the latch bolt but not re-lock the trim?

Resolution: Tips for changing the function: The NL Drive screw will not be visible when lock body is set to Classroom function There is locktite on the screw that makes it seem like its turned down enou...: