Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ LCN special templates with GJ ”

RELATED FAQS

Question
Answer
Where are hardware templates?
All the templates can be found at us.allegion.com   Please click here
Can a magnet, or sentronic device, be released and close the door from a button at a desk?
If a door is being held open by the LCN SEM 7800/1900 magnet or any ME/SE Series Sentronic LCN closer, you can remotely release that door to close by ordering the following parts and wi...
Can I mount an LCN Cush closer with an GJ overhead stop?
It would be unnecessary to use the CNS/Cush arm and the Glynn Johnson overhead devices in the same application, both mechanisms stop the door.
What special template (ST) is used with a 4040(XP) Rw/PA mount closer and a GJ overhead stop?
The use of a 62A Shoe (required) would be used to mount a 4040XP Parallel Arm  with a "SURFACE" GJ 70, 79, 81, 90, or 450 series stop. You would order the 4040XP with a Reg w/62A arm op...
What special template (ST) is used with a 2030 closer and GJ over head stop?
Special template ST-2211 is used to mount a 2030 series closer with a GJ 70,79,81,90, and 450 series overhead stops. This ST works with any GJ "surface" mounted stop. The 2030 closer cannot b...
Can a 4040 regular mount installed on the pull side and a Glynn Johnson 90 be mounted together?
The LCN 4041/4040XP and the Glynn Johnson 90 series can be mounted in conjunction with each other without a special template.  The 4040 door closer is on the pull side of the door and the GJ 90 is ...