Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ IVES HINGE SIZE ”

Resolution: Butt hinges can be used on doors up to 4' wide and 200 pounds. There is no maximum door height. However, an additional hinge must be installed every 30" when exceeding a 7' d...:

What is the hinge backset for 1 3/4" thick door?

Resolution: Hinge backset is the dimension from the leading edge of the hinge to either the stop on the frame or to the stop face (push side) of the door. For operating clearance, the hinge backset on the d...:

Does Steelcraft use a 7 gage hinge reinforcement on their frames?

Resolution: Steelcraft uses a 7 gage hinge reinforcement for 4 1/2" and 5" butt hinges as standard on all frame series. The hinge reinforcement size for either 4 1/2" or 5" hinges (standard or heavy duty hing...:

What is the standard screw size used on Steelcraft doors with 4 1/2" or 5" hinges?

Resolution: Steelcraft follows the industry standards for hinge reinforcement and preparation for both door and frame. Unless otherwise specified all products prepared for butt hinges will have mounting holes ...:

What is the difference between the FE and DE-Series frames

Resolution: A Double Egress frame is a double door frame prepared to receive two single-acting doors swinging in opposite directions (both doors are) the same hand. These openings are installed in cross corrid...:

Do we offer the Ives butt hinges in 609 finish?

Resolution: The 609 finish is not available with Ives butt hinges.:

Where is common cutout for Von Duprin EPT prep in Ives 224 Continuous Hinge?

Resolution: Cutout depends on the size of 224 hinge. See 112HD/224HD-EPT template. 112HD/224HD continuous hinge Center line of EPT to top of the door 83 inches 30 inches 85 inches 32 inc...:

Does Ives offer a continuous hinge or pivot for lead lined doors?

Resolution: Ives does not offer a continuous hinge designed specifically for lead lined doors. Standard hinges may work if the hinge and mounting hardware do not penetrate the lead lining in the door.&nb...:

What is the part number for the rubber tip for an Ives hinge pin door stop?

Resolution: Model 69 the part number is 09-310Model 70 & 73, the part number is WSPART.1075:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ IVES HINGE SIZE ”

RELATED FAQS