Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ ISO for Door Closer ”

RELATED FAQS

Resolution: The 62A shoe is used when it is necessary to install the door closer (lower) down on the door so that it will operate under accessories such as overhead stops, coordinators, etc.:

What special template (ST) is used with the 2030 closer and a low profile track and roller?

Resolution: The 2030 closer requires a minimum 1-3/8" top rail on the door for the standard track. For a top rail less than 1-3/8" and as narrow as 1", you could use the l...:

Can you order a 1461 cylinder only?

Resolution: The part number is: 1461-3071 for the door closer cylinder body.:

Can the 4630/4640 cylinder only be replaced?

Resolution: The 4040(XP) door closer can be used as a temporary replacement in a 4630/4640 operator to provide manual control of the door while the 4630/4640 closer cylinder is being repaired or a replacement ...:

Can you manually pull a 4040SE out of hold open?

Resolution: The holding force on an SE/ME Series door closer is approximately 35 lbs. and they can be manually pulled out of hold open with approximately 35 lbs of force. :

Can a 4010 be mounted with swing clear hinges?

Resolution: Locate closer and arm from the centerline of the swing clear hinge pin.:

Can a pull side mounted 1460 open 180°

Resolution: A 1260 Pull Side can be mounted standard template for 180°, frame and trim permitting.:

In what direction should the hold open nut be pointing for a 4041 H closer, up or down?

Resolution: Make sure that the hold open nut is not on upside down. The orientation of the hold open nut depends on the mounting. On a Top Jamb "Push Side" mount, the hold open nut would poi...:

Does LCN still make a closer that has the built in smoke detector?

Resolution: The SED/MED series closers were discontinued in 2000. The SE or ME series from LCN can be used as replacements to provide a hold open feature, but will not have the smoke detectors a...: