Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ is VD El Device solenoid driven ”

RELATED FAQS

Question
Answer
What could cause the Von Duprin EL solenoid not to hold when mechanism cover plate is slide over the solenoid?
If mechanism cover plate causes the EL solenoid to drop when slid over the solenoid, the solenoid plunger requires adjustment.  You must lengthen the rod by turning the hex nut in front of the plun...
What is needed to keep the EL device retracted all day?
To keep the Von Duprin electric latch retraction EL or QELA exit device dogged (retracted) all day, have your access control, Key pad, key switch, fire alarm contact or any other signals ...
How many thread should be showing on the solenoid plunger bushing on EL device to operate correctly?
The threaded bushing on the solenoid plunger requires 8-9 threads showing to operate correctly.
Can the EL solenoid be replaced in the former Monarch 17/18 devices?
It can but the solenoid will need to be purchased through New England Door Closer as the factory discontinued the old ELR solenoid (part #650092-000) in June 2010.
Does the Inpact EL94/95 have the same solenoid as the EL devices?
The EL94/95 Inpact solenoid is different than the EL33A/35A/98/99 solenoid. The part for the Inpact solenoid is 113189.  
As of 1/16/2013, the 113189-00 EL INPACT SOLENOID/PLUNGER ASSY is no longer available.
Are the Falcon EL solenoids rated for continuous duty?
The Falcon EL devices can be operated in a continuous duty cycle.
Is the 900-ELK wiring adaptor required when using the PS914 power supplies?
Products shipped on or after August 8, 2012 no longer require the EL wiring adaptor. The ELK Wiring Adaptor (900ELK) was used only when using the PS914 power supply with either the 900-2RS or...