Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ is there an exit alarm retrofit kit ”

RELATED FAQS

Question
Answer
What is the part number for the EAK PCB only for Monarch Falcon devices?
PCB only for the Alarm Kits prior to June 11th, 2012 is part #650335 and was used in the older 17 & 18 devices, 19, & pre June 2012 24/25's.
This circuit board will NOT work on the updated 24/25 Alarm Kits that released June 11th, 2012.
What cylinder is used in the Falcon 24/25 exit alarm kit?
The Exit Alarm takes a 1 1/8" Mortise cylinder with a straight cam. See first page of Exit Alarm inst below. Exit Alarm inst
If using the alarm kit-ALK with the 99 device what power supply is needed?
Exit alarm ALK operates with 9VDC battery and doesn't required a power supply.If you choose to hard wire the exit alarm ALK use the PS902 power supply.Exit alarm ALK requires 24VDC regulated power ...
What is the current draw of a Von Duprin exit alarm kit ALK?
The current draw of a Von Duprin exit alarm ALK is .25 amp when alarm is activated.
Is there an Exit Alarm Retrofit Kit (EAK) for the 19 series?
There is currently an Exit Alarm Kit for the 19 device. It is ordered by description: 19 EAK 3' x Finish 19 HWEAK 3' x Finish (Hardwired version) 19 EAK 4' x Finish 19 HWEAK 4'' x F...
Does a Von Duprin ALK kit come with an RX switch?
ALK kit comes with standard RX switch. It can be ordered without the RX switch or with LX switch as an option.
The Von Duprin 98 or 99 ALK kit will not sound the horn
Followings are the reason for 98/99 exit alarm ALK not sound when push bar is activated. Make sure key switch on exit alarm ALK is turned on, wait for 20 seconds before you activating the pushba...