Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ inrush current EL devices ”

Resolution: You can use a Von Duprin PS914 power supply with any of the following option boards depending on the application. 900-2RS board will power 1 or 2 devices that do not require timing from pow...:

What is the difference between the EPT 2 and the EPT 10?:

Resolution: The EPT2 has (2) 18 gauge wires and the EPT10 has (10) 24 gauge wires. Even though they are 18 gauge or 24 gauge wires they are special high stress, high flex, & high current wires specifically u...:

What size wire and run is recommended when using a PS914-2RS?

Resolution: For Product Shipped Prior to August 2012 using the old (black) potted module:a. 0-100 ft 14 gauge wireb. 0-200 ft 12 gauge wire&nbs...:

What is the purpose of the 900-2RS board?

Resolution: The 900-2RS option board is used with PS914 power supply to isolate the inputs such as key pads or card readers from the outputs for EL electric exit devices. The EL draws 16 amp inrush that needs...:

What wire gauge and run is recommended for Von Duprin electric latch retraction EL device?

Resolution: :

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ inrush current EL devices ”

RELATED FAQS