Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ handle is hot ”

Resolution: Von Duprin Exit Devices (33A/35A, 98/99, etc) are handled on a case by case basis regarding their ability to handle salt and chemical environments. Our powder coated finishes US28 (Anodized Alum...:

Can the Von Duprin 996L lever handle be replaced with a new one?

Resolution: Yes, Von Duprin 996L lever handle can be replaced with a new one . Attached installation instructions shown how to replace the existing lever handle on 994/996L trim for rim and vertical rod device...:

Why is my E996L solenoid getting hot?

Resolution: This is usually an indicator of applying excessive voltage. Measure the voltage going into the solenoid and make sure you have 24-26.4VDC cross the two wires going into the solenoid. Also measure ...:

Why would an EL 98/99 solenoid get hot?

Resolution: If voltage going into the solenoid is much higher than 24VDC it could cause the solenoid to get hot. Check the power supply output voltage to confirm. If the holding coil on EL solenoid is shor...:

Should a solenoid be hot to the touch?

Resolution: If there is concern that the solenoid or device is "too hot" or has the capability to cause injury, disconnect the device and contact a authorized service representative to analyze the opening.:

How hot do the 6000 electric strikes get?

Resolution: If the solenoid of the 6000 series electric strike is powered continuously with proper voltage at room temperature, the solenoid can feel very warm to the touch. Ensure the power supply ...:

What did the latch on the MD lock look like?

Resolution: The MD Handleset latches are no longer available. Pictures of the MD Handleset latches are not available. Illustrations of the latches are below. :

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ handle is hot ”

RELATED FAQS