graintech field finishing

RELATED FAQS

Question
Answer
Steelcraft does not offer factory powder coated doors and/or frames. Powder coatings usually require heat between 300 to 400 degrees to melt and cure the powder coat. The higher heat can ca...
When factory installed on GrainTech® doors: Finish Stain - YES, top caps, bottom caps and astragals are stained (prior to attachment) to match the GrainTech® door finish. GrainTech® Steel - NO, t...
GrainTech® doors are not available with different finishes on the inside and/or the outside door panels. Both panels must match. Standard GrainTech® finishes include: Birch Ash Oak Maple Ma...
Steelcraft frames and doors are furnished with a high grade, low gloss, baked-on prime paint that provides the best possible protection against corrosion, abrasion and weather, and is an excellent ...
The DS is Dual Monitor Switch for Von Duprin 6000 series electric strikes. DS option cannot be added to a Von Duprin 6000 series electric strikes in the field. It is only available factory inst...
The function of the 812L trim was determined by the device itself for a Rim or Surface vertical rod device. See the appropriate device instructions(link below) under the  "Locking ...
The 4582 is handed because the latch pocket is not centered on strike plate. the 4582 can't be handed in the field. See attached information: 4582 Handing
The 55 devices are handed, but they can be reversed in the field by following the reversing instructions.