Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ french door fitting ”

RELATED FAQS

Resolution: Surface Mounted door closers are the most durable and common type of door closer. Mounted to the surface of the door or frame Can be configured (through installation or arm type) to meet a...:

What parts do I need to convert my AL lock to fit a 2" thick door?

Resolution: Part required by function:2 each A700-043 driver & A700-034** lever insert in addition to the chassis parts below:AL10S – 2 hubs A700-028AL25D – 2 hubs 1 A700-028 (inside), 1 A700-030 (outside)...:

Can the Falcon 25-V be cut to fit on a 2' door?

Resolution: The standard Falcon 25V vertical rod cannot be cut to fit on a 2 feet door opening. This device requires 2' 7 1/8" minimum door opening. Falcon offers a device that can be used on a 2 feet doo...:

Will the AL lock fit a 2" thick door standard?

Resolution: The AL series lock fits up to 1 7/8” door thickness out of box.:

Can you cut the EL conversion kit - 3' base plate to fit a 30" 9947 device?

Resolution: You need to order the EL98/9947 or 3' EL conversion kit. This will fit on 28 1/8" minimum door opening on two vertical x vertical rod device doors.:

What is the maximum door thickness a Rim cylinder can fit on?

Resolution: For total thickness measurements larger than 3 inches see the special cylinder offerings in the Schlage Pricebook. Specify the part number and include the total thickness. We do no...:

What is the narrowest door a 99 rim, single door can fit on?

Resolution: The Minimum single door opening should be 26.32" and use the 299 or 499F strike.:

What is the minimum opening that a Chexit 4' device can be cut down?

Resolution: The Von Duprin CX 98/99-4 feet Rim devices on single doors with 5/8" stops and the standard 299 roller strike can be field sized to fit a minimum of 40.2" door opening. This an...:

What parts are needed to install a T lock on a 1 3/8" door?

Resolution: If the lock has not been ordered then specify a door thickness of 1 3/8" and a shim kit will be provided to allow installation on a thin door. If the lock has already been ordered then order ...:

Can an ND lock with SFIC cores be extended to fit a 3" extended outside door?

Resolution: ND locks can be extended up to 6" Extended Outside. :

Can the 2670 be cut down to fit smaller door widths?

Resolution: The 2670 Guard X device can't be cut down to fit doors less than 3 feet. This device is designed to fit doors 36"- 48" in door width.:

What are Overhead Concealed door closer?

Resolution: Overhead Concealed door closers are used to provide a more aesthetic look to the opening. Concealed in either the frame or the door Offer the ability to be adjusted to maintain...:

What is the minimum stile for Schlage locks?

Resolution: The minimum stile for each lock will depend on the backset and the rose diameter/escutcheon width. See the Schlage Minimum Stile Requirements for the minimum stile for eac...:

Will new 3347A fit in the old 3347 door prep?

Resolution: To replace an old 33/3547 exit device with a new 33/3547A exit device the door would need to be modified. The new device will cover any changes to the door prep. See attached templates for retrof...: