Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ fire, life safety and accessibility codes ”

RELATED FAQS

Resolution: Hold Open Closers & Magnets (Fire/Life safety products) provide a wide range of solutions. Single or multi-point hold open closers Utilize an electromechanical closer. Hold the door o...:

Can a magnet, or sentronic device, be released and close the door from a button at a desk?

Resolution: If a door is being held open by the LCN SEM 7800/1900 magnet or any ME/SE Series Sentronic LCN closer, you can remotely release that door to close by ordering the following parts and wiri...:

What is clear opening width?

Resolution: Clear Opening Width for swinging doors is measured (with the door open 90 degree) from the face of door to stop soffit on strike jamb. &nbs...:

What is delayed egress hardware?

Resolution: Delayed egress hardware prevents a door from being opened from the egress side, usually for a period of 15 seconds. This type of device is often used to prevent theft, while maintaining life safe...:

What is the difference between Panic Hardware and Fire Exit Hardware?

Resolution: The most obvious difference (in the device) is the lack of mechanical dogging on a Fire Rated Device. There are some internal parts that may be different and the method it is secured to the d...:

When are Panic Devices required?

Resolution: The use of Panic Hardware and/or Fire Exit Hardware is required by the International Building Code (IBC) and NFPA 101 – The Life Safety Code, depending on which code and which edition of the code i...:

Can you replace just the solenoid in the 4040SE, 4040SEH, 3130SE, 2310ME, 4310ME?

Resolution: The solenoids are not replaceable by themselves but can be ordered with a subassembly. On the SE products the track must be replaced, specify finish and voltage On the ME products the cylinder mus...:

Can a Cam Lift hinge be used with LCN closers?

Resolution: Cam Lift hinges can only be used with LCN door closers that have a "Regular" or "Reg hold Open" style arm. Manual Closers:Maximum lift dimension is 3/4".Can not be use (H)EDA, CUSH, or T...:

What maintenance is required for an LCN closer?

Resolution: Closers mounted according to LCN installation instructions require no periodic maintenance or seasonal adjustments. Monthly, quarterly, and annual visual inspections are recommended for Fire/...: