Field instructions graintech

RELATED FAQS

Question
Answer
Steelcraft frames and doors are furnished with a high grade, low gloss, baked-on prime paint that provides the best possible protection against corrosion, abrasion and weather, and is an excellent ...
The 55 devices are handed, but they can be reversed in the field by following the reversing instructions.
Steelcraft offers two optional types of reinforcements for open section header to be installed in distributor shop or in the field: Full profile sleeve; is a 14 gauge, 16" long part to fit the p...
The lock case can be re-handed, however, this requires opening up the lock case. See M lock re-handing instructions for a complete guide.
The function of the 812L trim was determined by the device itself for a Rim or Surface vertical rod device. See the appropriate device instructions(link below) under the  "Locking ...
The 4582 is handed because the latch pocket is not centered on strike plate. the 4582 can't be handed in the field. See attached information: 4582 Handing
Steelcraft does not offer factory powder coated doors and/or frames. Powder coatings usually require heat between 300 to 400 degrees to melt and cure the powder coat. The higher heat can ca...