Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ falcon power supply ”

Resolution: The Von Duprin PS914 power supply with either the 900-2RS or the 900-4RL option board is required.:

What is the input / output of the 8200 series operator?

Resolution: The Falcon 8200 series operator requires a input of 120 VAC @ 1 Amp.:

Why would a Falcon 8200 Series operator be blowing the fuse?

Resolution: If the Main AC fuse is blowing, the control box is defective and needs to be replaced. The "Main Fuse" is a (5x20MM) 1 Amp Slow Blow fuse. If the 12VAC fuse is blowing, verify they are not trying...:

Is the instruction sheet for the PS 902 on the Von Duprin website?

Resolution: The installation instruction for PS900 series power supplies are available online under the Von Duprin, Falcon exits, Schlage, and Schlage Electronics sections of the website. You can also find by...:

Will the PS914 or PS873 replace the RDS-2?

Resolution: This is not an option, the older RDS-2 was used with the older Falcon Monarch ELR devices. The power supply would apply 24VDC for 1 second then drop down to 5VDC for the remainder of h...:

Does Falcon offer a Delayed Egress exit device?

Resolution: There is not a fully self-contained delayed egress like a Von Duprin Chex-It device but the Falcon RX-24 or RX-25 Series can perform a delayed egress by using the DE5300 controller, power supp...:

What power supply replaces the Von Duprin MPB840 or MPB842?

Resolution: MPB840 = PS914power supply, MPB842 = PS914-2RS power supply.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ falcon power supply ”

RELATED FAQS