Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ fail safe electric strike and card reader ”

RELATED FAQS

Resolution: Electronic Protocols: Access Control Door with electric trim Access Control with electric strike Access control with electric strike and LCN 460...:

Can the 6300 electric strike be Fail Safe?

Resolution: The Von Duprin 6300 surface mounted electric strike is only available as Fail-Secure.:

How to convert the Von Duprin 6000 series electrical strike from Fail Secure to Fail Safe or Fail Safe to Fail Secure?

Resolution: Part numbers: FS slider, part # 090591 (Use for all EXCEPT 6211WF/6212WF/6221/6223. See 090798 below) FS slider, part #090798 (Use this slider for FS models 6211W...:

Why would an electric strike not stay locked when turned upside down?

Resolution: The Von Duprin 6000 series electric strike has a 12 or 24VDC solenoid with plunger, spring and impact washer as shown 6000 solenoid Make sure the solenoid spring and impact washer are not missin...:

Why won't the 5100 24v strike work on both a RH & LH door?

Resolution: The 5100 strike details are listed below: Only operates with 12VDC or 24VDC power supply. Will not operate with AC transformer. 12 or 24VAC can be converted to 12/24VDC using Von Duprin SO12 o...:

What is the amount of pre-load force allowed for the 6300 electric strike before the strike will no longer release and operate properly.

Resolution: The 6000 series electric strikes 6100, 6200, 6300 models, require that there be no preload at all on the strike lip to function properly.:

Can 24 volts be run to a 12 volt 6000 series electric strike solenoid?

Resolution: You can't run 24VDC into the 12VDC electric strike, over voltage such as this will cause the solenoid to heat up and damage the solenoid. You must change to a 24V solenoid, part number 050240-00.:

Does the 9540 Senior Swing need a separate relay board for wiring to electric locks?

Resolution: The Senior Swing control box has a built in (programmable) relay output for connection to a Fail Safe/Fail Secure electric strike/maglock or to an EL Device power supply.: