Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ exit device spring ”

RELATED FAQS

Question
Answer
Is the Von Duprin Guard-X exit device fire rated?
The Von Duprin Guard-X exit device is not fire rated because the deadbolt is not spring loaded. Therefore, there would be no positive latching as required on a fire rated opening. 
Why doesn't the AD-Series-Exit Device communicate with the Hand Held Device after rehanding the lockset?
During the rehanding of an AD-Series Exit (993) device or the rehanding of a CO-Series Exit (993) device it is possible for the customer to damage the 5-inch pcba by using the wrong screws.  D...
What are the part numbers for the end case and latch case springs for the 88 rim?
The part number for 88 rim end case spring is 090003-00 (PKG of 2) or 090080-00 (PKG of 10) and latch tail spring is 050393-00 (PKG of 10).
Is the deadlocking spring replaceable on a 19-R device?
The spring itself is not replaceable, you would need to replace the 19 centercase assembly.
Why would an exit alarm ALK go into alarm and shut off after about 10 seconds?
If the spring on the Von Duprin exit alarm ALK board is not located correctly as shown on the instructions, then the vibration from the horn allows the cylinder to turn and shut the exit alarm ALK ...
What could cause the Von Duprin exit alarm ALK to turn off after one or two minutes?
If the spring on the Von Duprin exit alarm ALK board is not located correctly as shown on the instructions, then the vibration from the horn allows the cylinder to turn and shut the exit alarm ALK ...
Does EL or QEL conversion kit for Von Duprin exit devices contain mechanism cover plate?
The conversion kit does not contain a new mechanism case cover plate.  If a cover plate is desired, you would need the Fire or Less Dogging Cover Plate for EL/QEL conversion kit and Panic cove...