Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ ept location with pivots ”

Resolution: EPT installation guidelines are as follows:Recommended location is 6" below top hinge per template.Steelcraft will locate the power transfer prep at the Von Duprin recommended template location of ...:

Where is common cutout for Von Duprin EPT prep in Ives 224 Continuous Hinge?

Resolution: Cutout depends on the size of 224 hinge. See 112HD/224HD-EPT template. 112HD/224HD continuous hinge Center line of EPT to top of the door 83 inches 30 inches 85 inches 32 inc...:

Where is the EPT location of a Pin-and-Barrel Continuous HInge?

Resolution: The 600/700 Series EPT Template shows recommended locations based on the standard sizes, The customer can provide a different dimension measured from the top of the hinge to the Cen...:

What degrees of opening can a 4110 EDA be templated for?

Resolution: The 4110 EDA/HEDA can be templated for 100°, 140°, and 180° hold open. The hold open adjustment can be set to hold the door at any position (degree) up to the maximum door opening angle. For "Wi...:

Does Ives offer a continuous hinge or pivot for lead lined doors?

Resolution: Ives does not offer a continuous hinge designed specifically for lead lined doors. Standard hinges may work if the hinge and mounting hardware do not penetrate the lead lining in the door.&nb...:

Can a 450 overhead be used on a 48" wide door hung with butt hinges or offset pivots?

Resolution: The 455 can be mounted on a 48" wide door, but we cannot guarantee that it will withstand the forces involved. Recommend using 906 instead.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ ept location with pivots ”

RELATED FAQS