Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
Engage sectors are full
”
RELATED FAQS
Question
Answer
What does HTTP Bad request mean? Error Code: 407?
Resolution:
Error Code 407 usually indicates that NoTour sectors are full. It could also mean a FW update to the MT20w is needed. Try updating FW on the MT20W. Also try confirming that at le...:
Olivari Door Stops
Resolution:
:
When are Panic Devices required?
Resolution:
The use of Panic Hardware and/or Fire Exit Hardware is required by the International Building Code (IBC) and NFPA 101 – The Life Safety Code, depending on which code and which edition of the code i...:
How to install Olivari door stops.
Resolution:
Door stop. Door stop magnetic. :
Olivari door stop dimensions.
Resolution:
Dimensions shown are in millimeters. Cubo & Cubo Mag have the same dimensions. Victor & Victor Mag have the same dimesions :
What is delayed egress hardware?
Resolution:
Delayed egress hardware prevents a door from being opened from the egress side, usually for a period of 15 seconds. This type of device is often used to prevent theft, while maintaining life safe...:
What is the part number for T lock tailpiece used with a conventional cylinder?
Resolution:
Refer to Table 1 for a list of T lock tailpieces for conventional cylinders. Table 2 shows IC tailpieces. Table 1: T lock conventional tailpieces Table 2: T lock IC tailpieces:
How do I identify the old Falcon T lock latch from the new T lock latch?
Resolution:
For T locks shipping mid-June 2013, the new latch can be identified by viewing the deadlatch profile. The profile of the deadlatch has changed from a "full moon" to a "half-moon". See figure below....:
Can the AL locks be ordered to accept Corbin Russwin core?
Resolution:
The AL lock can not be ordered to accept any competitor full size core. The ND lock should be used in these applications.:
What is the part number for a L mortise lock spindle?
Resolution:
The Schlage L-Series mortise lock spindle and spring part number can be found in the Table 1. Spindles and Springs Part Number Description L283-060 Spindle and spring, 1...:
Can I get the T series with a Schlage Full Size Interchangeable core?
Resolution:
The T lock can accept a Schlage Full Size core, but the cylinder suffix must be specified as "J IC-SC" so the correct parts are supplied (including the tailpiece) Example: T581J IC-SC:
Why can't I remove the control key from the core after the core is inserted into the lever?
Resolution:
The lever may be missing the slot feature for the core locking lug. Verify slot is in place.: