electronic deadbolt reseting programming code

RELATED FAQS

Question
Answer
The programming processes for Allegion devices can be both product and features specific.  Some products programming processes are electronic in nature, others are physical in nature. &nbs...
-         With the CIP NOT inserted and the Schlage Utility Software (SUS) running o   Enter the Master Programming PIN or Present Loc...
To clear the memory on a CT500 controller, deleting all programming and codes from the controller and resetting to factory defaults, perform the following procedure: 1.   ...
To program the 8310-865 receiver: Set the dip switches 1 to the "OFF" (pulse) position. Set the dip switches 2 to the "OFF" (0.5s) position. Momentarily press the " No Delay" or "Delay" ...
Early versions (12/09 ) of the AD200 User Guide in many DEMO kits incorrectly state the Programming sequence to change the a programming code. It shows entering the new programming code o...
1. Press and hold the Schlage button. Wait for the lock to beep twice and two green blinks of the Schlage button, indicating a confirmation. 2. After confirmation signals, release the Schlage butt...
Toggle codes will change the main relay state indefinitely.  To return to the initial state a toggle code must be entered again..   To program a Toggle Code into...
For resetting a PED500 / BE367 deadbolt back to factory status, refer to attached guide:  Deadbolt Reset InstructionsProgrammable Electronic Deadbolt: RESET back to factory settings  It ...