Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Electrified openings hardware ”

RELATED FAQS

Resolution: Knock Down (KD) frames: KD frames are designed, manufactured and supplied with integral miters which include all notches, interlocking corner tabs and slots to allow for field assembly and do not r...:

What is the minimum clear opening width required by ADA on a single door?

Resolution: The minimum clear opening width for ADA is 32" measured from face of door opened to 90 degrees to face of stop on strike jamb. There must be no hardware mounted to the door projectin...:

What are the maximum door width and height sizes?

Resolution: Maximum nominal (overall) single door sizes are as follows:L-Series (Laminated Door)20 Gage = 3’ 0” wide X 8’ 0” high18 Gage = 4’ 0” wide X 10’ 0” high16 Gage = 4’ 0” wide X 10’ 0” high1...:

What is the definition of double egress?

Resolution: Double Egress Opening: A pair of swinging doors, each leaf which swings in the opposite direction of the other. DOORS: A pair of doors swinging in opposite directions without a vertical mullion....:

Can the LM9000 multi lock series be used in standard openings?

Resolution: Specify either an L or B doors for use with the LM9000 or LMV9000 Specify the F frame for use with the LM9000 or LMV9000 Order the lock from Schlage as you would normally The concealed rods...:

What is a Pocket Door Frames?

Resolution: POCKET DOOR FRAME: A frame designed to allow a door to slide inside a pocket located within the cavity of a wall. The hinge jamb of the frame is replaced with a 2 piece jamb without a stop. I...:

160-4

Resolution: Lock Prep, Cylindrical Lock Prep for Knob trim; ANSIA115.2, Door Lock PrepA 160-4 lock is a cylindrical lock preparation. The lock has a 2 1/8” diameter bore through the door with a 2 3/4" backset...:

ACP

Resolution: Access control panel is a central repository receiving information from electrified openings and processing these signals according to predefined parameters.:

What is clear opening width?

Resolution: Clear Opening Width for swinging doors is measured (with the door open 90 degree) from the face of door to stop soffit on strike jamb. &nbs...:

Would the 900-4R option board control EL devices in a PS914?

Resolution: The 900-4R is used with PS900 series power supplies and has four independent outputs and inputs with no time delay. You can use any of these outputs with electrified hardware including EL devices a...:

When would you use the 900-4R option board in a 900 series power supply?

Resolution: The 900-4R is used with PS900 series power supplies. The 900-4R has four independent outputs and inputs with no time delay. You can use any of these outputs with electrified hardware including EL...:

What power supply is used with RX or LX switches?

Resolution: The RX switch is request exit and the LX switch is latch bolt monitor switch. They do not require a power supply directly. The electrified hardware that the RX or LX switch...:

Will the PS861 power an EL99?

Resolution: The PS861 will not power an EL device. The high 16Amp current of the EL requires the PS914-2RS, PS914-4RL or the older PS873-2 power supply to operate.:

Are astragals required on fire doors?

Resolution: Astragals are required on: 3 hour fire rated pairs: Double doors - swinging in the same direction Double Egress - swinging in opposite directions Fire rated Dutch Doors Fire rated 1 3/4" t...:

Are Steelcraft doors and/or frames fire rated?

Resolution: Yes, Steelcraft doors and/or frames are available and can carry a UL, WH or FM label. The type of fire label (UL, WH or FM) is dictated by the specifications and local building code. Doors ...: