electric exit trim not working when energized

RELATED FAQS

Question
Answer
Von Duprin does not recommend using XP98/99 devices with any electric strike.   Von Duprin recommends using the standard 98/99 rim device.  The XP device has 2000 pound holding forc...
The E996L-FSE trim is needed if the application requires fail-secure operation from the trim side of the opening. When power is out on Chexit device, E996L-FSE trim will remain locked to ...
There is not a K hub on the 19R or a 19V as the device uses a main cam.
The LP1000 series Kabba Simplex trim will not work with the 19 series devices.
The Schlage AD/CO trims are not compatible with the Falcon 25-V device due to the main cam on the device rotating the opposite direction for a given hand compared to the AD/CO trims output dri...
- AD Series and CO series products require that the Night Latch (NL) screw is installed in the exit device.  Be sure this screw is installed- Exit hardware and strike must be properly mounted ...
The 25-R or 25-V device does meet the trim input requirements set by KABA for their trim so the two should be compatible.  However, the KABA trim has never been tested in house for the Fa...