Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ eda special template gj ”

RELATED FAQS

Question
Answer
Can I mount an LCN Cush closer with an GJ overhead stop?
It would be unnecessary to use the CNS/Cush arm and the Glynn Johnson overhead devices in the same application, both mechanisms stop the door.
What special template (ST) is used with a 4040XP with a non-adjustable (solid) regular arm for pull side mounting?
Special Template ST-2795 is used to mount a non-adjustable (solid) regular arm for pull side mounting.   
What special template (ST) is used with a 2030 closer and GJ over head stop?
Special template ST-2211 is used to mount a 2030 series closer with a GJ 70,79,81,90, and 450 series overhead stops. This ST works with any GJ "surface" mounted stop. The 2030 closer cannot b...
What special template (ST) is used with a 4040(XP) Rw/PA mount closer and a GJ overhead stop?
The use of a 62A Shoe (required) would be used to mount a 4040XP Parallel Arm  with a "SURFACE" GJ 70, 79, 81, 90, or 450 series stop. You would order the 4040XP with a Reg w/62A arm op...
Can a 4041 EDA be mounted top jamb?
The 40401/4040XP closer with optional EDA arm has to be mounted parallel arm on the push side of the door.
Where are hardware templates?
All the templates can be found at us.allegion.com   Please click here
Can you mount a 4041 Cush arm with a EDA arm template and get 180 degrees opening?
The dead stop post would need to be removed and the 4040/4040XP EDA mounting template for 180° would be followed.
Does LCN still make a 4010SE / 4110 SE?
The LCN 4010SE / 4110 SE series are obsolete, and on longer available. They were replaced by the 4040SE series. The 4010SE / 4110 SE track is replaced with the current 4040SE trac...