Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ EDA HOLD OPEN ”

RELATED FAQS

Resolution: The 1460 Regular Arm part numbers are: Regular Arm -- 1460-3077 or 1460-3077L for long arm (must specify finish). Regular Arm with PA -- 1460-3077PA (must specify finish). Regular Hold Open Ar...:

What degrees of opening can a 4110 EDA be templated for?

Resolution: The 4110 EDA/HEDA can be templated for 100°, 140°, and 180° hold open. The hold open adjustment can be set to hold the door at any position (degree) up to the maximum door opening angle. For "Wi...:

Can a 1460 EDA open to 180°?

Resolution: The standard 1460 EDA arm is not long enough to allow the door to open 180°.ST-2430 is a special 1460 EDA arm that will allow the door to open 180°.:

HEDA

Resolution: Hold Open Extra Duty Arm:

HEDAW/62G

Resolution: Hold Open Extra Duty Arm w/ Thick Hub Shoe, Hold Open Extra Duty Arm with Thick Hub Shoe, Thick Hub Shoe:

Can a 4110 EDA and a Glynn Johnson 100 be used together?

Resolution: A special template is not needed, the closer drops down far enough on the door where it does not conflict with the GJ100 series concealed overhead stop. :

HEDAW/145

Resolution: Hold Open Extra Duty Arm w/ Flush Transom Shoe, Hold Open Extra Duty Arm with Flush Transom Shoe, Flush Transom Shoe:

What would cause a 4111 HEDA to not hold open?

Resolution: The correct method (process) for setting the hold open is: The 4110 HEDA arms are handed, verify correct hand arm. (RH or LH stamped on shoe bracket) Loosen the hold open nut at shoe bracket. ...:

How do I set the hold open on my 4040 closer?

Resolution: The hold open position on a "REG" or "EDA" hold open arm is set with the door to a few degrees shy of the desired hold open point. To properly set, open the door 5° less then the desired hold open...:

Can you mount a 4041 Cush arm with a EDA arm template and get 180 degrees opening?

Resolution: The dead stop post would need to be removed and the 4040/4040XP EDA mounting template for 180° would be followed.: