Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ DW frame installation ”

Resolution: It is always recommended to point installers to the industry installation manuals which are very comprehensive and are ANSI documentsClick here to get the updated link to the Steelcraft Shop M...:

How many compression anchors are provide per jamb on DW-Series frames?

Resolution: For compression anchor details refer to the “ANCHORING SYSTEMS” section in the Steelcraft Tech Data Manual.Anchor Quantities: • 1 compression anchor per jamb through 9"depth • ...:

Can steel frames be installed after the wall board is installed in stud wall applications?

Resolution: DW and K-Series frames are designed to slip onto a stud wall after the wall is finished (painted, wall papered, etc).Walls can be either wood stud or steel studUsed only for interior appl...:

Can out of plumb (twisted) frames be adjusted?

Resolution: Out of plumb (also referred to as twisted) frames usually cannot be adjusted."Out of Plumb or Twisted frames (or jambs)" is a condition created by improper wall construction and/or improper in...:

Can out of square frames be adjusted?

Resolution: It is the responsibility of the installing contractor to install all material in accordance with SDI or HMMA installation standards and tolerances. Out of square frames which are installed out...:

What are the installation tolerances for hollow metal frames?

Resolution: Industry standards for hollow metal frames installation tolerances have been developed by both the SDI (Steel Door Institute) and HMMA (Hollow Metal Manufacturers). Both standards are based on th...:

Can a filler or cover plate be used to blank out a EPT prep on a fire rated frame?

Resolution: Yes, a filler plate can be used to cover an EPT prep as long as it is made from the same material as the frame. This information can also be found in NFPA 80 under Chapter 5 for Field Modifications.:

What options are available to add frame reinforcement for surface closer?

Resolution: Steelcraft offers two optional types of reinforcements for open section header to be installed in distributor shop or in the field: Full profile sleeve; is a 14 gauge, 16" long part to fit the p...:

How do you install a 4110 with flush transom frame?

Resolution: The 4110 series closer is installed on a flush transom frame using the -419 flush panel adapter.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ DW frame installation ”

RELATED FAQS