Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
doors shop drawing
”
RELATED FAQS
Question
Answer
Are window kits available for Steelcraft doors?
Resolution:
Window kits are available for Steelcraft doors as either factory installed or prepared and installed by a distributor. Factory prepared light cutouts are supplied with Dezigner trim as ...:
Steelcraft field paint instructions
Resolution:
Steelcraft frames and doors are furnished with a high grade, low gloss, baked-on prime paint that provides the best possible protection against corrosion, abrasion and weather, and is an excellent ...:
Can Steelcraft doors be powder coated?
Resolution:
Steelcraft does not offer factory powder coated doors and/or frames. Powder coatings usually require heat between 300 to 400 degrees to melt and cure the powder coat. The higher heat can ca...:
SHOP DRAWINGS
Resolution:
Approved Submittal Drawing:
What is the power draw of a Senior Swing series operator?
Resolution:
The Senior Swing (2800/9500) Series operator has a 120VAC @ 2.5 Amp current draw for a single door (2811/9531/9542) or simultaneous pair(2853/9553). The independent pair units (2863/...:
What is the difference between Night Latch (NL) and Class Room function?
Resolution:
Night Latch (NL)= key retracts the latch momentarily to allow entry. When key is removed, the latch will extend and locks the door (momentary unlock). Class Room (Lock/ Unlock)= key unlocks...:
Did Falcon ever make a lock for elevator doors?
Resolution:
Falcon manufactured an EZF101 which was a large plate with a recessed lever for use in elevators. This item is no longer available. :
What is exposed glass size?
Resolution:
When dealing with glass lights in doors, there are three (3) critical dimensions which must be coordinated: Exposed Glass Size (EGS) - the horizontal and/or vertical dimensional size of the vision...:
What is the minimum dimension from the edge of the door to a glass light cutout?
Resolution:
Minimum dimensions to cutouts for glass lights: Vertical edge of door to edge of cutout = 5 29/32" Top of door to top of cutout = 6" Bottom of door to bottom of cutout = 10" Reinforcing chann...:
Can a Von Duprin delay egress controller DE5101 run a pair of doors?
Resolution:
One Delayed Egress Controller (DE5101) can run two mag locks on a pair of doors, provided the doors are not controlled independently:
What do you do if rust spots show up on steel doors and frame material?
Resolution:
During the construction cycle, spot rust is usually attributed to either material handling damage or improper storage of the material on the jobsite. The material must be repaired and repainted as ...:
What causes doors and/or frames to rust?
Resolution:
Prime or painted surfaces which have been scratched or otherwise marred during installation (including field welding) and/or cleaning must be field repaired and re-primed by the installing contractor.:
What mounting group do I use if my hinge type is not listed in the Glynn Johnson overhead door holder and stop instructions?
Resolution:
To determine if a Glynn Johnson overhead device will fit on a door with special considerations, we will need the following details: What overhead stop/holder series and size are you w...:
How do I get a special template for a Glynn Johnson overhead stop or holder with special door considerations?
Resolution:
To determine if a Glynn Johnson overhead device will fit on a door with special considerations, we will need the following details: What overhead stop/holder series and size are you want...: