Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Door hinge chart ”

Resolution: When installing the arm; the gearbox shaft and door must be at the (+90°) full open position. The following step are used to install the Sr. Swing (REG) push arm. Install t...:

Are factory finished doors and frames available from Steelcraft?

Resolution: Factory finished painted doors are available from Steelcraft. Frames "are not available" factory finished from the factory.Doors are offered in variety of standard colors or can be finish...:

Can I use a Glynn Johnson 410 with a 4040 regular (pull side) mount?

Resolution: ST-1630 is required when mounting a 4041 or 4040XP door closer regular (pull/hinge) side with a concealed GJ100 or GJ410 series over head stop.This ST also REQUIRES the use of a 4040-18TJ drop plat...:

Where is the Fire Label located on a door and a frame?

Resolution: Fire labels (UL, ITS/WHI or FM) are located as follows: Butt Hinges and Pivots: On the doors the fire label is located on the hinge edge between the top and 2nd hinge preparation. On the fram...:

What is maximum width, height and weight for IVES butt hinges?

Resolution: Butt hinges can be used on doors up to 4' wide and 200 pounds. There is no maximum door height. However, an additional hinge must be installed every 30" when exceeding a 7' d...:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Door hinge chart ”

RELATED FAQS