Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ DOOR CLOSER DWG ”

RELATED FAQS

Resolution: The 62A shoe is used when it is necessary to install the door closer (lower) down on the door so that it will operate under accessories such as overhead stops, coordinators, etc.:

What special template (ST) is used with the 2030 closer and a low profile track and roller?

Resolution: The 2030 closer requires a minimum 1-3/8" top rail on the door for the standard track. For a top rail less than 1-3/8" and as narrow as 1", you could use the l...:

Where are hardware templates?

Resolution: All the templates can be found at us.allegion.com Please click here :

Can the 4630/4640 cylinder only be replaced?

Resolution: The 4040(XP) door closer can be used as a temporary replacement in a 4630/4640 operator to provide manual control of the door while the 4630/4640 closer cylinder is being repaired or a replacement ...:

What are the dimensions of the SC70 footprint

Resolution: The measurements from center line to centerline of the mounting holes are 2-3/8" x 6-3/4".:

Can a 4010 be mounted with swing clear hinges?

Resolution: Locate closer and arm from the centerline of the swing clear hinge pin.:

In what direction should the hold open nut be pointing for a 4041 H closer, up or down?

Resolution: Make sure that the hold open nut is not on upside down. The orientation of the hold open nut depends on the mounting. On a Top Jamb "Push Side" mount, the hold open nut would poi...: