Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
diagram for tallpiece in cylinder
”
RELATED FAQS
Question
Answer
Why does my AD or CO series lock unlock when the lever is raised?
Resolution:
Installers have reported that their AD-CO Series cylindrical or mortise locks will unlock whenever the outside lever is lifted. This will occur if the outside spindle (square post) is install...:
What is the length of a Schlage rim cylinder?
Resolution:
The Schlage rim cylinder lengths are given below and were measured from the face of the cylinder to the back of the tailpiece. Because of allowable tolerances for each part the average length is l...:
When ordering the ND lock less cylinder will it come with a tailpiece?
Resolution:
The Schlage ND is shipped with a driver/tailpiece when ordered with a LD, BD, or JD suffix.:
What is the part number for the Schlage small format rim cylinder tailpiece?
Resolution:
B502-899 is the tailpiece for both the SFIC and standard rim cylinders.:
What is the part number for T lock tailpiece used with a conventional cylinder?
Resolution:
The Falcon T series was discontinued August 12th, 2026 and was replaced by the Falcon TM series. Refer to Table 1 for a list of T lock tailpieces for conventional cylinders. Table 2 show...:
What is the part number for the Schlage cylinder to work in a Falcon T lock?
Resolution:
The Falcon T series was discontinued August 12th, 2026 and was replaced by the Falcon TM series. Schlage offers Falcon Retrofit cylinders to fit many of Falcon's locks. Table 1 below con...: