Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
Deadbolt will not retract completely
”
RELATED FAQS
Question
Answer
Does Schlage make a mortise lock that the lever on either side retracts the latch and a key on either side retracts the deadbolt?
Resolution:
The L9466 Store/Utility Room lock can provide this functionality. Operation: Latchbolt retracted by knob/lever either side. Deadbolt thrown or retracted by key from either side. When the deadbolt ...:
Why doesn't full rotation of the AD or CO Series Exit Trim (993) outside lever fully retract the Von Duprin 98/99 Exit Device latch?
Resolution:
- AD Series and CO series products require that the Night Latch (NL) screw is installed in the exit device. Be sure this screw is installed- Exit hardware and strike must be properly mounted ...:
B663 only throws bolt and wont retract it.
Resolution:
After installing a classroom deadbolt, there is potential for the thumbturn to project the bolt only, get stuck in one position, or move both directions but not move the bolt. These are caused fro...:
Why can't I order an AD-Series or CO-Series mortise deadbolt with a classroom/storeroom (70) function
Resolution:
* NOTE: the AD300/400 devices simply communicate the change in Deadbolt Position status to the Host software. The software then decides what action should or should not be taken at the device. :
Why does my 7500 retract the latch bolt but not re-lock the trim?
Resolution:
Tips for changing the function: The NL Drive screw will not be visible when lock body is set to Classroom function There is locktite on the screw that makes it seem like its turned down enou...:
Why does my Trilogy Lock not retract the latch when I replace a lever trim on a 98/99 series device?
Resolution:
If the NL screw on the 99 device has been removed the Trilogy lock will not retract the latch. :
What replaced the B400 deadbolt?
Resolution:
The Schlage B400 deadbolt was a grade 2 deadbolt and was discontinued April 1, 1996. Its replacement was the B100 grade 2 deadbolt and no parts were compatible between the two.: