Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ d lever inserts ”

RELATED FAQS

Question
Answer
Can you use lever trim on a 19V-EO without getting any additional parts?
The Exit Only (EO) device will accept any 19 Series trim as the main cam for the trim input is always put on the device center case.
What parts do I need to convert my AL lock to fit a 2" thick door?
The easiest method to obtain an AL lock for a 2" door is to specify a 2" thick door when ordering.  
Part required by function:2 each A700-043 driver & A700-034** lever insert in addition to the chassis parts below:AL10S – 2 hubs A700-028AL25D – 2 hubs 1 A700-028 (inside), 1 A700-030 (outside)...
How are interchangeable cores installed?
A control key is required to install or remove an interchangeable core from a housing or lever. The control key is identified by having "CONTROL" stamped on the bow. How to install and remove an i...
What is the part number for the lever insert on an AL lock manufactured before May 2002?
A700-015, standard cylinder lever insert.
What is the difference between the standard lever inserts for the pre-2002 AL and the old D Lever?
The old D-Series Lever used a standard lever insert similar to the pre-2002 AL-Series standard lever insert.  The old D Lever insert was smaller than the AL and the two were not comp...
Did the AL series SFIC lever inserts change?
There was a design change in 2001 for the driver and lever insert on the AL for SFIC products.  Changing the driver and/or lever insert on locks manufactured prior to 2001 will requi...
 The SFIC lever insert part number prior to 2001 was the A700-022.
Why can't I remove the control key from the core after the core is inserted into the lever?
The lever may be missing the slot feature for the core locking lug.  Verify slot is in place.
Can the Schlage danmark levers be added to the 996?
The Schlage Danmark levers are not available on the Von Duprin 996L lever trim.