Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
cylindrical lock boring template
”
RELATED FAQS
Question
Answer
Is there a tool to drill the thru bolt holes on cylindrical locks?
Resolution:
Order the M204-198 thru-bolt jig, see Figure 1. Figure 1: M204-198 thru bolt jig The 40-080 was the old Schlage jig. The 030736-000-70 was the old Falcon jig. When the jig changed to...:
Why are there two different bore sizes on the templates for the B500 and B600 deadbolts?
Resolution:
The bore size is dependent on the function of the deadbolt. Some functions can be installed into a 1 1/2" or 2 1/8" bore while others require 1 1/2" only. You need to reference the dead...:
What is a Grade 2 Lock?
Resolution:
Grade 2 locks are tested and certified to be in compliance with the following ANSI/BHMA Standards: Cylindrical, Bored and Preassembled Locks & Latches 400,000 Certified Cycles ANSI...:
What is a Grade 1 Lock?
Resolution:
Grade 1 locks are tested and certified to be in compliance with the following ANSI/BHMA Standards: Cylindrical, Bored and Preassembled Locks & Latches 8...:
Is there a template that shows where to drill the hole for E/EL/SS/RX/LX/CX wires?
Resolution:
The hole should be drilled in the field once the end cap is located on the door. It is a 5/8" hole, that is located 5/16" from the end of the mechanism case. See installation instruction of t...:
Which electric strike do I use for cylindrical locks used in a single door?
Resolution:
The 6211 would be the most common electric strike to be used with cylindrical locks on a single door application. Check the template to confirm compatibility with specific cylindrical lock model n...: