Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ cush hold open ”

RELATED FAQS

Resolution: The 1460 Regular Arm part numbers are: Regular Arm -- 1460-3077 or 1460-3077L for long arm (must specify finish). Regular Arm with PA -- 1460-3077PA (must specify finish). Regular Hold Open Ar...:

What is the part # for the 4040 HCush arm?

Resolution: The part number for the 4041/4040XP HCush arm is 4040XP-3049CNS.:

How do you order a 4110 hold open spring cush arm only?

Resolution: The 4110 hold open spring Cush (Spring H Cush) arm part number is 4110-3049SCNS.:

When did the 4111 Cush arms become non-handed?

Resolution: This engineering change did affect the templating of the closer. The stop in the shoe is slightly larger than the original handed cush shoe. The new non-handed arm template locates the closer and s...:

SPRING HOLD-OPEN CUSH ARM

Resolution: SHCUSH,:

HOLD-OPEN CUSH

Resolution: HCUSH, PA Mount, Parallel Arm Mount:

Can you mount a 4041 Cush arm with a EDA arm template and get 180 degrees opening?

Resolution: The dead stop post would need to be removed and the 4040/4040XP EDA mounting template for 180° would be followed.:

Can a 4040 open to 180°?

Resolution: The 4040/4040XP closer mountings have the following maximum opening degree templating: The 4040/4040XP PA "Regular Arm" mount will allow for 180° max. opening. The 4040/4040...:

What is the maximum degree of opening you can template a 4110 Cush closer?

Resolution: The 4110 Cush closer can be templated for 85°, 90°, 100°, and 110° maximum as standard templates.The 4110 if ordered by ST-3220 will allow templating to 135°:

How do I set the hold open on my 4040 closer?

Resolution: The hold open position on a "REG" or "EDA" hold open arm is set with the door to a few degrees shy of the desired hold open point. To properly set, open the door 5° less then the desired hold open...: