Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ clear opening width for double egress openings ”

RELATED FAQS

Resolution: Clear Opening Width for swinging doors is measured (with the door open 90 degree) from the face of door to stop soffit on strike jamb. &nbs...:

What is the difference between the FE and DE-Series frames

Resolution: A Double Egress frame is a double door frame prepared to receive two single-acting doors swinging in opposite directions (both doors are) the same hand. These openings are installed in cross corrid...:

What is the minimum clear opening width required by ADA on a single door?

Resolution: The minimum clear opening width for ADA is 32" measured from face of door opened to 90 degrees to face of stop on strike jamb. There must be no hardware mounted to the door projectin...:

What astragals are available?

Resolution: Types of astragal offered from Steelcraft are as follows: "Z" Astragal - For information on "Z" astragal types and attachment refer to the TD Manual page 3.3.17. Most commonly used on double ...:

What is the definition of double egress?

Resolution: Double Egress Opening: A pair of swinging doors, each leaf which swings in the opposite direction of the other. DOORS: A pair of doors swinging in opposite directions without a vertical mullion....:

What is the minimum door opening width for mounting the 4640 or 4630 on a double door?

Resolution: The minimum door opening width (for mounting a pair of 4640 or 4630 operators on a double door) is 72" wide (2 - 36" door leaves). Mounting the 4640 or 4630 on a double door that is less than 72" w...:

Can DE-Series frames be prepared for pocket pivot hinges?

Resolution: Pocket pivot hinges are mainly used in cross corridor applications where clear opening width is a factor. For frames, pocket pivot hinges are a special hinge options which must be spe...:

What is the narrowest door a 99 rim, single door can fit on?

Resolution: The Minimum single door opening should be 26.32" and use the 299 or 499F strike.: