Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
cl factory programming pin
”
RELATED FAQS
Question
Answer
How do I program Locknetics CM / CL legacy locks with the Schlage Utility Software (SUS) and Hand Held Device (HHD)?
Resolution:
- With the CIP NOT inserted and the Schlage Utility Software (SUS) running o Enter the Master Programming PIN or Present Loc...:
How do I manually change PIN length on an AD200?
Resolution:
Beginning with Firmware Packages ADFwPkg 2.16.3 and COFwPkg 1.20.0 the PIN length can be manually changed for AD200 and CO200 locks as follows: 1. Press {programming code (default is 97531)} then ...:
Why does my AD-200 not accept a new programming code?
Resolution:
Early versions (12/09 ) of the AD200 User Guide in many DEMO kits incorrectly state the Programming sequence to change the a programming code. It shows entering the new programming code o...:
How to Reset a BE367 Deadbolt to Factory Settings
Resolution:
For resetting a PED500 / BE367 deadbolt back to factory status, refer to attached guide: Deadbolt Reset InstructionsProgrammable Electronic Deadbolt: RESET back to factory settings It ...:
Toggle code on a KP 232 Keypad
Resolution:
Toggle codes will change the main relay state indefinitely. To return to the initial state a toggle code must be entered again.. To program a Toggle Code into...: