Can i replace retract solenoid on von duprin push bar

RELATED FAQS

Question
Answer
If the Chexit device shipped prior to 8-24-2015  is not adjusted correctly ( Check vertical rod or Mortise finger) without using the door position switch and nuisance delay is&n...
 
The push bar end cap is only included in the push bar replacement/retrofit kit (PBKIT) because the end caps are riveted to the push bar.   
How to order:  specify devise type, size, and finish.  Example: PBKIT 33A 3' US28
This solenoid is replaceable and the part number is 050671.
Order E-Trim Mech Kit  part #050671-00 which will include a new solenoid already mounted to the blocking mechanism. See installation instruction # 921297 here which will show how to remove block...
  Pushing on the push  bar or activating the EL/QEL or the trim on Von Duprin XP98/99 exit device does not retract the latch, it releases the latch only. Door must be pushed or pulled when device o...
The following may cause the ALK to go into alarm: Make sure red and blue wires on the RX switch are connected to the exit alarm ALK terminal block and yellow wire is taped off. Check the red an...