Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ aux fire latch template ”

Resolution: If a door is being held open by the LCN SEM 7800/1900 magnet or any ME/SE Series Sentronic LCN closer, you can remotely release that door to close by ordering the following parts and wiri...:

FIRE LATCH

Resolution: Aux Fire Latch, Turkey Popper:

What is the difference between Von Duprin 98/9947 and 98/9948 concealed vertical rod devices?

Resolution: They both use Template # 10320_c:

Where can I find templates for the 237L two point latch device?

Resolution: Click HERE for the instruction and template for 237L device.:

Can Steelcraft doors be prepped for the 98/9949 Concealed Vertical Cable Exit Device?

Resolution: Yes, as an option, Steelcraft doors are available with factory prepared for the 98/9949 Concealed Vertical Cable Exit Device.L, B, CE, T and CE-Series doors are available factory preparedDoor prepa...:

Where do I install my Auxiliary Fire Latch (AFL) in a Less Bottom Rod, Fire Rated (LBR-F) exit device?

Resolution: Installation should be 6" from bottom of the door. See attached templates as reference. T-5494 for HM Doors W-5494 for Wood Doors:

What would cause an EL device to pull and release?

Resolution: If your Von Duprin EL (solenoid) device pulls and releases quickly instead of holding the latch retracted, please check all of the items below.In most cases, one or more of these solutions will r...:

How do I wire an EL device to normally hold open the latch and release it during a fire alarm?

Resolution: Use a normally closed fire alarm as the input to the power supply option board (PS873-2 or PS914-2RS), this will hold the latch retracted. During a fire alarm, the contact will open, dropping...:

Does Von Duprin have a fire latch that will go into the floor?

Resolution: Auxiliary fire latch is tested only from door to door latching by Von Duprin. Some door manufacturers have tested our devices LBR and use additional fire latches to pass the fire test. Contact the ...:

At what degree will the AFL (Auxiliary Fire Latch) bolt release?

Resolution: 1400 degrees which is approximately 20 minutes after the fire starts.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ aux fire latch template ”

RELATED FAQS