Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ are power supplies requiered for electric locking trim ”

Resolution: Follow the steps below to troubleshoot the problem. Measure the voltage at the electric strike. If the strike is FSE and not locking there should be no voltage at the strike and if it is FS there ...:

What is the most common practice for running electric power from a frame to the door and hardware?

Resolution: Electrical hinges or a power transfer units are the most commonly used practices to run electric power to locks and/or strikes. Electric Hinges: Most electric hinges will fit into...:

What power supply is used to operate the Von Duprin E 996 L trim?

Resolution: The Von Duprin E996L trim required .22 amps at 24VDC.:

What is the Falcon cam designation for use on 25 series trims?

Resolution: For standard (non-IC) cylinders, use the Falcon #4 straight cam For IC cylinders, use the Falcon #5 cam :

Can you use lever trim on a 19V-EO without getting any additional parts?

Resolution: The Exit Only (EO) device will accept any 19 Series trim as the main cam for the trim input is always put on the device center case.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ are power supplies requiered for electric locking trim ”

RELATED FAQS