Ives does not offer a continuous hinge designed specifically for lead lined doors. Standard hinges may work if the hinge and mounting hardware do not penetrate the lead lining in the door.&nb...
Cutout depends on the size of 224 hinge. See 112HD/224HD-EPT template.
112HD/224HD continuous hinge
Center line of EPT to top of the door
83 inches
30 inches
85 inches
32 inc...
Ives does not offer any lead lined pivots.
An appropriate model of pivot would be determined by the weight of the door and where the lead lining is in the door. Because ...
Templates for 224HD TW8 continuous hinges are 829431-00 for 83" & 85", 829433-00 for 95" & 829435-00 for 120" tall doors.
Templates for 112HD TW8 continuous hinges are 829430-00 for 83" & 85", 82...
Hinge manufacturers do not require or recommend that doors should be reinforced for continuous hinges. Steelcraft does not reinforce for continuous hinges unless it is specified on the customers' P...
The door template L1 states:
"Lead Lining: When L9000-Series or L400-Series locks are ordered with lead lining, add 1/8" to the width of the mortise cut-out on the lock case cover side of installa...
Doors require special downsizing for continuous hinges. The amount of downsizing depends on the hinge specified (manufacturer and type) and the hinge application (Full Mortise versus Full Surface v...
Use mounting group 2 per templates below when a GJ 100 and 410 series overheads are used with continues hinges. 100 series overhead instructions 410 series overhead instructions
The determination was made that Lead Lined covers are no longer needed for the LCN product line, see below Marketing/EHS document.
Lead Lined cover discontinuation letter
The 600/700 Series EPT Template shows recommended locations based on the standard sizes,
The customer can provide a different dimension measured from the top of the hinge to the Cen...
Lead lined frames are intended for use in the X-ray Room locations in Health Care facilities.
Frames are provided by Steelcraft prepped as follows:
Frames are supplied knock-down (KD).
Fram...
The standard gap between a pair of doors will be 3/16" when used with a Steelcraft "Z" astragal. If a wide inactive leaf is requested (no astragal) the gap between the doors will be...
The following hinges are available on Paladin series doors and frames:
Butt hinges - 4 1/2", 5" or 6" ball bearing type either standard or heavy duty
Continuous hinges - full mortise...
Fire labels (UL, ITS/WHI or FM) are located as follows:
Butt Hinges and Pivots:
On the doors the fire label is located on the hinge edge between the top and 2nd hinge preparation.
On the fram...