Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ amp draw on schlage electrified ”

RELATED FAQS

What is the power draw of a Senior Swing series operator?

Resolution: The Senior Swing (2800/9500) Series operator has a 120VAC @ 2.5 Amp current draw for a single door (2811/9531/9542) or simultaneous pair(2853/9553). The independent pair units (2863/9563) have a 12...:

What is the amp draw of the LCN ME and SE closers?

Resolution: 24 volt version draws 90 mAmps (0.090A). 120 volt version draws 30 mAmps (0.030A). See here for the LCN catalog sheets that contain this information (page 2 of 48). :

What is the draw amperage for the E996L?

Resolution: PS902 is a 2 amp power supply and each E996L electric trim draws 0.25 amps at 24VDC. You can have up to eight E996L electric trim per PS902 power supply.:

What are the Falcon T lock electrical requirements?

Resolution: Prior to June 2011 the T lock only supported 24V and the electrical requirements were as follows: 0.185 amp @ 24VDC Wire Gage 22 AWG See wiring diagram here - (Previous 2 wire versi...:

How much amperage does the QEL draw?

Resolution: Applies only to Von Duprin QEL exit devices shipped after December 11th, 2014.1.0 amp inrush and a 0.14 amp holding current.:

Will a PS902 power my mag lock and my DE5101?

Resolution: This is possible as long as the total current draw does not exceed the 2 amp capacity of the PS902 power supply. The Schlage Electronics 320, 350, or 390 maglock must be used with a DE5101 and th...: