Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
AL series installation
”
RELATED FAQS
Question
Answer
Schlage AL small format spacer installation requirements.
Resolution:
The Schlage AL-Series SFIC locks require one (1) small format spacer (D500-000) for 7-pin cores and two (2) small format spacers for 6-pin cores. When these spacers are not ins...:
New FSIC driver info for the AL locks.
Resolution:
The new AL FSIC driver part number is A700-052. This driver snaps onto the back of the core similar to the ND, as opposed to it being assembled into the lock chassis with a retaining ring. Th...:
AL-Series Plunger Assembly Instructions
Resolution:
Changing the plunger assembly on the AL-Series requires disassembling the chassis. Refer to Plunger Assembly Instructions for guidance.:
Why can't a new spring cage or driver be installed on an older AL lock?
Resolution:
In 2002 the Schlage AL-Series underwent a design change that affected the spring cage, driver, and plastic insert. Spring cage and driver replacements for AL locks manufactured before this design ...:
Why can't I remove the control key from the core after the core is inserted into the lever?
Resolution:
The lever may be missing the slot feature for the core locking lug. Verify slot is in place.:
Can you install a Schlage S lever on an AL lock?
Resolution:
You can not install the S lever onto an AL lock. The AL and S lever trim is not compatible with each other.:
How do I identify an AL lock?
Resolution:
The AL-Series has four distinguishable parts that can help in lock identification. 1. The AL-Series will have a castle nut holding the chassis on the ...:
Can out of plumb (twisted) frames be adjusted?
Resolution:
Out of plumb (also referred to as twisted) frames usually cannot be adjusted."Out of Plumb or Twisted frames (or jambs)" is a condition created by improper wall construction and/or improper in...:
Can out of square frames be adjusted?
Resolution:
It is the responsibility of the installing contractor to install all material in accordance with SDI or HMMA installation standards and tolerances. Out of square frames which are installed out...: