Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
Adding failed, could not connect
”
RELATED FAQS
Question
Answer
Why did my CO Lock stop working after the Reader Module (electronics) was changed?
Resolution:
CO Reader Modules are not individually replaceable, nor can they be swapped between locks. The inside and outside assemblies of a CO lock are a matched/mated set and cannot be swapped to change rea...:
How do I clear the HandNet for Windows error message, "Index or primary key cannot contain a null value" on a biometric HandKey?
Resolution:
This HandNet for Windows message appears only when a HandKey 2 connects to it for the first time. During the uploading of users from the HandKey 2 to HandNet, the software verifies the user d...:
The Hand Held Device (HHD) or Schlage Utility Software (SUS) will not connect to the CO200?
Resolution:
Make sure the HHD/SUS is set to USB communication by checking the small icon right of the "No Device Connected" message. The symbol should be a USB symbol when working with USB enable product...:
Why won't my HHD connect to the AD300 lock?
Resolution:
If the AD300 power is not correctly connected it may not communicate or other wise function correctly.The AD-Series locks must be hard wire powered through the comm board. It is not com...: