Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

Schlage Electronics

What credential readers can I use with a CT5000?

Resolution: You can use the MTK15 and the SEKPD88 The older KP70+ Series keypad is NOT compatible with the CT5000. The CT5000 requires that keypad data be transmitted in 2-wire Wiegand (Data...:

How to set up the XceedID keypad reader as a 26Bit wiegand output?

Resolution: Follow the steps below to make the reader an SFX2110 reader a card or pin. Step1: Power cycle the reader Step2: Within 1 minute from power on perform one of the following task: Enter * 8 8...:

How to set up the XceedID keypad reader as a 26Bit wiegand, 4bit, or 8bit burst output?

Resolution: XceedID™ Customer Application Note Keypad formats 5/13/2009 XceedID-KeypadFormats Page 1 of 1 Step1: Power cycle the reader Step2: Within 1 minute from power on perform one of the following t...:

CT5000 Reader Compatibility

Resolution: The CT5000 will accept a clock and data or a Weigand reader.And is compatible with the following devices and others.MTK15 reader with keypad configured as 8 bit burst output for programming.SXF2110...:

Is the KTP-162 reader used with the CT-5000?

Resolution: The KTP-162 can't be used by itself as a stand alone access control device. The KTP-162 is an 8 bit word output keypad, so it just sends keypad number signals to a stand alone controller ...: