Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Resolution: Twin Pack - 2 single cylinder Dexter deadbolts and 2 keyed entry Dexter knobs all keyed alike.:

Resolution: The Backset is the distance from the center of cross-bore hole to edge of door; Schlage residential locks accommodate 2-3/8” and 2-3/4”. Some locks can be fitted with a 5" backset, but will require...:

What is BLE / Bluetooth Low Energy

Resolution: a version of Bluetooth wireless protocol; used in BE479:

How does the LX switch operate with cable devices 9849 / 9949 / 3349 / 3549?

Resolution: #1. The LX switch monitors the trim input. In other words, the LX switch will change states (open or close) momentarily when the lever is stroked. #2. The LX switch will monitor the latch...:

Why won’t my AD200 work with the remote release feature?

Resolution: · You must have a PCB with revision “F” or higher. · Be sure to properly wire to the normally open and common of the switch ...:

Will the current 8200 series console add on switches fit the older Locknetics version?

Resolution: Yes, the 8200MS and AS switches are compatible. The new consoles are the same as the older ones so they will fit.:

Can AD200 or CO200 locks be programmed with a two man rule?

Resolution: No they cannot. There would need to be two separate users with their own credentials to gain access. In standalone mode or with Schlage Express Software this is not possible to program.:

Can the 320M maglock be installed on a swinging door or only for sliding door application?

Resolution: This is for sliding doors only.:

On the CO-220, if the lock is in an unlocked toggle state and the fob is pressed for lock down, it will lock and then the fob is pressed again to take it out of lock down, will it go back to the unlocked state?

Resolution: The lock will resume the previous state when the lockdown is removed.:

On a M492 with the HDB490, are the shims required to be installed for the HDB?

Resolution: Yes, the shim places even pressure against the glass surface. Without the shim the screw is directly putting pressure on the glass. &nbs...: