Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Resolution: When using CL Locks only the following can be used as programming credentials. The factory default programming code 97531* A CL Programming card that has been encoded as a CL Prog...:

Cables to use 101+ with KP Keypad

Resolution: When using any KP keypad with a 101+ magnet make sure they are using the three wire cable called the 100CAB and not the 770CAB. With a three data line input the unit must be initialized to understa...:

How can I find out which firmware each AD-Series model should have?

Resolution: All Allegion associates can go to this SharePoint site for firmware, software releases and technical bulletins. Follow the link provided HERE and make it one of your "FAVORITES" for...:

Why would a 4600 not open a full 90 degrees?

Resolution: A 4600 (4630/4640) not opening to a full 90 degrees could be caused by a couple things: The Opening Force could be set too low. Try increasing the opening force adjustment on the controller a 1/...:

Schlage SXF1100 Reader - what does "D" designate in the model number

Resolution: The "D" represents a default configuration on the reader.:

Can Battery drain issue be resolved on the KC 2 Series with a firmware upgrade

Resolution: Early versions of the KC cannot be upgraded.To determine if a lock can be Flashed Press the * button 5 times.A single green flash indicates the unit can be flashed .No response Indicates and earl...:

Auto and Manual Update Mode on the SUS How do I set up my HHD to do auto updates? Why won't my HHD do auto updates?

Resolution: Check the configuration of the HHD /SUS.Update Mode:When Auto Update is selected, the SUS will automatically set the date and time in the lock to which it is connected, retrieve the audit and progr...:

How will a Schlage ANT400-REM optional remote antenna improve my installation?

Resolution: Use an ANT400-REM-I/O when the PIM400/PIM401/WRI400 is located in a central mounting location and extra height is needed for the antenna to be above metal cabinets or objects. Use ...:

Can I manually program AD locks?

Resolution: Only AD200 locks with keypad-equipped credential readers (e.g., KP, MSK, MTK, etc.) can be manually programmed. AD250, AD300, AD301, AD400 and AD401 locks support Cons...:

ANSI Numbers with Maglocks

Resolution: ANSI number Product cross reference can be found in the back of the price book. For example, ANSI number E08561 is specifically for the GF3000, GF3000TJ: