Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Can I convert an L9000 electrified lock to fail safe or fail secure?

Resolution: Procedure for the L9080EL/EU and L9082EL/EUTo modify an electrified L9000 from EU to EL or EL to EU move the link pin to the appropriate location indicated below in Figure 1. :

What is a composite card?

Resolution: The composite material on our credentials is a 70/30 blend of PETG (polyethylene terephthalate glycol or thermoplastic polymer) to PVC (polyvinyl chloride). Being made of this composite mater...:

How do I identify the various programmable locks from schlage?

Resolution: How many buttons does the lock have?v 6 ButtonsØ Are the buttons surrounded by metal or black plastic?§ Metal – Cobra§ Plastic – CM/CL/PROØ Is there an iButton port un...:

Where is the cross reference list for PS800 to PS900 series power supplies?

Resolution: Von Duprin PS914-4RL power supply replaces the PS873-4TD.:

How to request a custom arch door special for an LCN closer?

Resolution: Send request for Arch Door specials Forms and Informational sheets; Arch Door Request Form and Dimensional Sheet with Examples to [email protected]....:

Can 912L be re-handed in the field?

Resolution: The 912L trims produced after 2/28/2011can be re-handed in the field. See appropriate 912L instructions at 912L instructions for trims after 2/28/2011For 912L instructions on trims prior ...:

AD 993 Spindle and hub Kit parts guide clarification

Resolution: In the AD Series Service Manual shows the same part number 46929295 for the 993R, 993S, and 993M. The pictures show that the 993R and 993S have a flat straight tailpiece and the 993M has the square...:

Does an ND50 or ND53 unlock when closing the door?

Resolution: Both the ND50 and ND53 will not unlock when the door is shut. The only way to pop the button is by turning the key on the outside or the lever on the inside. Occasionally custome...:

Bent Pins on the Pigtail/Base of an Xceed ID / Schlage Reader

Resolution: If the reader head needs to be removed from a base with pent pins, this need to be done carefully to avoid further damage. -By using a small screwdriver between the edge of the reader and the base...:

CX will not arm. Red light on solid waits 10 sec, light goes out and cycle repeats

Resolution: Inadequate power or wrong gauge wire is used. The inrush current demand by CX will overload and shutdown the power supply if undersized. You must use the Von Duprin PS873 or...: