Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Is there a special template (ST) for 4111 HCUSH AND CUSH with 1/4 weatherstrip?

Resolution: ST-1586 is used to template a 4110CNS/4110HCNS closer with 1/4" solid weatherstrip and a 7/8" 5th screw spacer. For all LCN PA mounting with ¼” weatherstrip special template numbers – se...:

What is the recommended door to jamb gap?

Resolution: Per NFPA (National Fire Protection Association) 80 section 6.3.1.7 the door to jamb gap should be 1/8" + 1/16".:

Repalcement parts for Schlage Electronics 672 TouchBar and 692 SmartBar

Resolution: See attached table: Schlage 692/672 Parts Cross ref:

What is the part number for the ALK sign?

Resolution: The sign for exit alarm, ALK, is SIGN-1.:

What was the LCN SEM7870 magnet?

Resolution: Only available replacement part is the LCN SEM7820-825 armature. The SEM7820-516 magnet coil might be able to use but may not be a direct replacement. :

Can a filler or cover plate be used to blank out a EPT prep on a fire rated frame?

Resolution: Yes, a filler plate can be used to cover an EPT prep as long as it is made from the same material as the frame. This information can also be found in NFPA 80 under Chapter 5 for Field Modifications.:

Can the 237 be used as LBR?

Resolution: The 237 device can't be used as LBR.:

What replaced the Falcon Z?

Resolution: The Falcon W replaced the Z lock in July 2006. The Z lock was a cylindrical chassis.:

Why can't I get my JD YA6 cylinder to install into an AD-Series lock?

Resolution: The JD YA6 tailpiece is intentionally designed such that the tailpiece cannot be installed at the same time as the cylinder. Interchangeable cylinders assume that the lever and taipiece is i...:

Can we use a pullman latch on a 5547 WDC?

Resolution: You cannot use the pullman latch/ES latch with 5547WDC exit device.: